Search:

Hi, I finally got the c axis working, but now, when I call the tool, it doesn't start. Does anyone think it's wise to disconnect the tool and connect it into another terminal to see if it works? Or...

Bruce, I got the manuals and I found the original parameters of the machine, had to checked them one by one, manually. I found differences in: Parameter 0390, it was 00000001, it's supposed to be...

Finally, changing some diagnostic bits, I've enabled the 4th axis. It seems to work ok, but a couple of things bother me. When a program is running, a lot of rumbe appears after a few seconds, then...

ok, this afternoon I found the 9xx parameters for the machine, so tomorrow afternoon hope to set them. Regarding the servo drives, I do have the manuals (series OM Controller) but I really couldn't...

Didn't work, any other ideas?

Yes, is a GE Fanuc OMC. I will try it right away, thanks

Hi, thanks a lot for your replies. I've set the bit 12, made it 0, bit 1005, made it 0, and bit 1023 and made it 4. Turned off and on the machine, but there's no 4th axis, and the servo drive unit is...

Hi! I just got a drive unit repaired for a fourth axis (C) on a Komo VR1005 TT Router and need to check if it's working ok. I have never seen the fourth axis on screen, and from fanuccncamerica they...