Pics?
I ordered my LCD tonight..
Type: Posts; User: Hellpit
Pics?
I ordered my LCD tonight..
Has anyone got a schematic for the legacy 88 control hand held pendant?
I'd like to try building my own if there is nothing fancy about it.
Thanks Neal, exactly what I was looking for. I shouldn't have an issue getting her in with the motor removed.
I think I'm going to get a bunch of 1/2" round bar cut to roll it around into place.
Thanks for the help guys.
With the head/motor removed, does anyone know the height from base to the top of the cabinets?
So I've got a VMC 15 XT being delivered. But I've just now thought about the hieght of my ceiling and garage door header.
My Ceiling is 8', 6"
Header is 7'
Can I take this apart to sneak it...
As far as I know, the G320 is grounded through the Power Ground terminal, not the chasis of the drive. (I could be mistaken though)
I'm not sure what value to use for the bleed down. I'm just...
Re your bleed down resistor, I have the same issue. I'm going to try a larger value resister to try and lower the current during drain. I'm using a 30 Amp contact relay, and it still looks like a...
I built the RC snubber you described. Worked like a charm! :banana:
Thanks again.
Thanks Al, that is the direction I needed.
I'm also going to try re-wiring the fan and relays on double pole switchs to switch the hot and neutrals at the same time.
In my installation, I am using a PowerOne MAP80 power supply for my 5 and 12 volts needs.
I am also running a 120V AC fan to cool the enclosure, as well as a large relay to control my bleed down...
I had the same issue until last night.
After two nights of bashing my head into a wall, and swapping out everything, the last thing that I could account was the position of the G320 in relation to...