Try this After down load look at the Calculator.
http://www.betatechnical.com/autonc.htm
Type: Posts; User: Rolly
Try this After down load look at the Calculator.
http://www.betatechnical.com/autonc.htm
I have been writing some G-code for the Mill. I put a pencil in the chuck and paper on a plate on the table. It was drawing out the X & Y tracing. Then I started to try some G-87 type stuff, never...
Paul
Hear is there Web Site
<http://www.mini-lathe.com/Default.htm>
Rolly
Paul
What’s wrong with a tapered adapter and chuck?
Andrew
Thanks for the information. I will look into this Software. Like Jim said I do need to learn how to write G-code for my machine. I tried last night and I do have to use V-codes with different...
eddiez
Yes Anilam uses G-code Some keyboard definitions of the keys are
Do (do loops)
SUBR (Subroutine)
CALL (to execute a subroutine)
END (a subroutine is a mini program it must have a End...
Paul
That’s one thing I’ve built a lot of. See my web site. I have one unfinished engine on the living room floor because I’ve been building boilers and getting the Bridgeport in and setup.
What...
Eddie
I looked up the Waynemark Software and have the address of the supplier in Pasadena CA You are saying this one program will convert an AutoCAD drawing to G-code and send it to the machine. I...
I just picked up a used CNC Bridgeport in the last six months. After rigging it into the cellar I needed to build a rotary converter to get it up and running. The controller is 110V and after...