Search:

should my g540 be getting hot just sitting plugged into the power and the printer port? Mach is running and im trying to figure out why my fault light wont go out. I have the charge pump turned on. ...

should my g540 be getting hot just sitting plugged into the power and the printer port? Mach is running and im trying to figure out why my fault light wont go out. I have the charge pump turned on.

Well That was fun.

I used tumutbound suggestion and had to hit the end of the pliers with a hammer to make it break free. The problem i believe was their was plastic bag all around the spindal...

Im using a steele belt drive kit on this thing. But im running into a little issue. i have removed the spanner nut no problem. But the little metel black ring below it seems stuck. In the you tube...

If i can read the gecko book correctly for my motors I should use a 3.5k resistor. I have some 3.3K what happens if i use that?

Thanks again for all your Help.

for the record these guys a good. They have replied already and have fixed the order.

I just saw that and dropped them an email.

Thanks Hoss.

I got this today.

You order KL23H2100-30-4B ( 3pcs they are out of stock)
we have
KL23H2100-35-4B (1/4” Dual shaft with a flat) 318 oz-in
Specification

After many moons of lurking i finally did it.

I ordered

1 Harbor freight X2 (44991-7VGA) (Small but i think it'll do)
1 CNC Fusion Kit #4 with helix
3 KL23H2100-35-4B X3 These say 30 days.
1...

Great thanks. I will try that I'm not going to be spinning anyware near that fast in real life I just thought I should be able to. .


Jason

I was using the Jog Function i used g-code also. As far as the rateing goes i cant realy tell whats its rating is. the manufature lists everything from 2v to 40v they have torque curves showing 12v...

No machine at all no lead screw. The motors rated at 12v i'm running 24 right now but plan on jumping to 48V soon but the specs on the motors say they where tested at 12V.

How fast should I be able to move my steppers I thought I could get around 700-1000 rpm my data sheet for my steeper has up to 20 rps. My brain says take 20 * 60 sec for 1200 rpm. Now I’m using...