http://i.imgur.com/50oEY6F.jpg
- - - Updated - - -
MISUMI SHIPS TO AUSTRALIA , CLICK PICTURE ABOVE
Type: Posts; User: Zvonkorp
http://i.imgur.com/50oEY6F.jpg
- - - Updated - - -
MISUMI SHIPS TO AUSTRALIA , CLICK PICTURE ABOVE
You are right I thought he was asking for mach4 - my mistake.
FWIW i did have to run the pokeys app first to set things like max stepper rate & a few other settings first, then went back into...
I believe the DMM drives accept step/dir inputs so you are correct that would be the way to go for him
The pulse engine configuration is found in the pokeys application, You must close mach first, then press windows button go to pokeys folder & open the pokeys application & then connect to your board...
I had an ma860h fail earliert his year and i got it running by replacing all the mosfets with irf640z . i think it might have had irf540s originally but i only had the 640s on hand and it got it...
I had a simliar driver blow up on me earlier this year, but upon disassembly the only thing i found that was damaged were several of the mosfets. I replaced all of mine with IRF640's as that is what...
Thanks for posting your progress in this thread it's greatly appreciated and has been a help to me in building my machine as well, i know sometimes on the zone these threads get a little empty or...
For a 200mm rail there would be two holes. Each one is 50mm from the ends and there is a 100mm gap in the middle between them. It's limited by nature by it's short length.
This is a picture of a...
Sorry for the double post, the other thread was in a section that hardly sees any kind of activity relative to this one, and this question is really more appropriate for this section anyway so if...
Here's where I am so far
25mm SSR THK rails/trucks for the Y axis (back/forth) - 640mm
15mm NSK rails/trucks for the X axis (left right, gantry, carrying the z) 880mm
20mm NSK rails/trucks for...
I got my table surface from misumi. I got 3 big extruded pieces of aluminum, measuring 15mm tall (about 5/8" thick) and 250mm wide (about 9 and 13/16") each. I joined 3 of them together to make one...
You can run 8-10 ms on the step pulse and 4-5 ms on the dir reliably i also have the 6560 drivers but at 24v mine runs rapids at 800 and cutting wise up to 600 on mdf & maybe 300/400 with light...
I use a high CFM delta fan mounted right in front of my spindle perpendicular to the bed (so it looks like it's standing straight up basically) - its a 120x38mm 3amp fan i got for a couple bucks off...