when try and move the Z axis it goes to this alarm
Type: Posts; User: 3DDonn
when try and move the Z axis it goes to this alarm
We did find that the fan is not working, finally found one online. So we are going to start with that. Thanks for all your help
Any ideas of why the VAC unit is overheating?
Hello,
We have a Okuma CNC Cadet with OSP Operating Panel 5020 LSY. When we first turn on machine it works fine, then after about 30 minutes, when machine is warmed up we lose the display on the...
I wanted to let you and anyone else having this problem know that the Alarm A106 E Overload actually stems from the Alarm 201-3 Alarm A Servo Amp X-Axis 2C6, we had to replace the BLII-D50-50A Dual...
Our CB1 is not mounted on the door and it doesn't have a reset on it. 196094 See the picture of fuses, only one light comes on these fuses, and it is the first one to the left. Any other...
Yes, our sending and receiving unit for programs. We unplugged it and tried restarting and still won't do anything? Is there something we can reset?
I have Alarm A106 EC overload. Machine is frozen, can't do anything. Any one have any solutions?
Getting Alarm 1118 VAC Power circuit low voltage. Manual says replace VAC Unit. Does any one know of any other suggestions? New unit is now $12,000.00 dollars. They won't do exchanges any more.
Yes it was hot, we pulled the back off of VAC unit and cleaned it. Seems to be ok now.
Thank you for your help!
VAC unit is overheating (replaced 2 yrs ago) causing machine to shut down.
I am receiving this alarm along with blowing out the 5 amp fuses. Is there another solution for this before we replace the VACIII drive. It was taking two or three tries before we can power up and...