Randy
whats the make of the servo drive/ machine
maybe we can find some detailed info on the signals
Although I remember seeing the terms A,B,C for encoders before. Most are A,B,and...
Type: Posts; User: carlcnc
Randy
whats the make of the servo drive/ machine
maybe we can find some detailed info on the signals
Although I remember seeing the terms A,B,C for encoders before. Most are A,B,and...
Randy
sounds to me like you have something not connected,
be sure you don't have the +5v and ground inverted.
are you sure the encoders are incremental? are the 5v ? some older ones are 12v...
mismis
go to homeshopcnc.com and then email them for suggestions
I believe your best bet would be their 740oz
you don't say what you want for top speed or how you will move machine...
cadfish
I've always wondered why an American company doesn't do spindles,
granted it's hard to compete with Chinese, but price isn;t everything
that said I think 3 and or 5hp 3phase...
diyengineer
first, I think I know your table, I scored 2 of them from Boeing years ago, sold the one you have to a guy near Lynden, ??
you have done a marvelous job
as to vacuum pump I have...
Has anyone used one of the "process" vacuum systems on their vacuum table?
this is where a roots blower feeds it's exhaust into a rotary vacuum pump?
Seems like a good idea,
the blower does...
I am probably looking for the impossible,but here goes
I have a lot of ground .75 face width 32pitch 20 degree rack
I am looking for some "rod" 2" dia [64t]to make pinions from.
Largest I have...
Just wanted to express my satisfaction with Dynomotion products.
I have built a 6x10 router with 3 spindles. there are 2 100 in.lb AC servos
slaved for moving my 800lb gantry, a 50in.lb. ac for...
I am near completion of a 6x12 router using a KFLOP and snap amps,
this machine has dual AC servos on X,and AC servo on Y, 3 independant Z axis with steppers.
it has taken a lot of input from Tom...
I used an air cylinder on my x axis and I just dialed up the pressure until I had the right preload. This was a lot simpler than Jack's method".
What a great fix!, also makes mounting a breeze!...
Harry
sorry for being away ,
the belts I used are 8mm ,HTD,30mm wide.
two thing sfor sure that I did not get right
all shafts/pulleys MUST have keyways,and tensioning the belts to be =...
Thanks for input guys,
Jack, unfortunately my machine is using one motor and jack shaft design instead of 2 motors ,
I think I have devised a way and design to incorporate some...
I recently went to a great deal of effort on a dual belt drive system
it did not work,
Now I have retroed with rack-pinion.
should the pinions be spring loaded against the rack?
Is there a...
Victors
thanks for reply,
Machine is for my own use, I have done several routers,from 2x2 up to 10x64.
this will be my first using brushless motors, tuning on bench with a scope is a...
Chip Sweeper,
I am about to instal 2 SST1500 UCX drives on a large gantry with ac servo on each side
is there a way to "slave" the drive outputs?,I think some people refer to this as...
I need a couple of 90 degree gearheads,
I can use ratio between 7:1 to 15:1
frame size 34 or 42 or metric size 90 or 115
off list please
thanks
Carl