Sorry, I do not have that.
Type: Posts; User: outctrl
Sorry, I do not have that.
Good morning. Can anyone tell if the z axis can be turned off on a Bridgeport Interact with a Heidenhain 151 control. I would like to drive the quill down without feedback. Thank you
Have a customer that has lost parameters on an Upgrade Technologies Lathe. OEM out of business. I have put in parameters and have machine running except that it will not change tools. Machine says it...
Have a Sodick A530 with an EX21 control. Two floppies, one used to boot. Does anyone know how to copy boot disk to user floppy.
Thank you in advance for any help
sold some feeler machines and have seen some feelers under different names. friendly machine and saileo come to mind. not bad machines.built well and usually have fanuc drives tho i sold one with an...
Been my experience that both lube and pressure switches in series. Also have seen Hardinges with oilers that have two switches in the oil tank. There is actually a timing sequence with these...
the operators are telling me that the spindle use to turn on in jog mode by picking direction and pushing the increase pushbutton. it will jog, but i can not get this to turn on. the machine is a T42...
Just saw this post. Is there a battery perhaps that is bad ? Yea, where am I coming from with that. Anyway, I have had experiences like this with Anilam controls. Both controls are PC based. Just...
crazy question, how is your machine grounded ? is it a ground wire to earth with ground rod or carried over as 4th wire, or is it carried over with conduit. make sure there are not two sourses for...
My question to all you Hardinge guys, trying to find out whether or not rigid tapping is available on these machines with Fanuc 18i controls. We can thread, so I can't see why not. Any help will be...
Need help with Yaskawa CIMR 37 1006 Turret Drive. Need to know where the ten wires coming off the pcb go. I know that 9 of them go to the transistor pack, but there is one left. Anyone there that can...
If I am not mistaken, you can send in control and Anilam will recondition and install hard drive for around $1500.00
you are lucky if it is just hitting you now. i am a service tech and also sell a line of machine tools and i can tell you that most of my customers have been on 32 hour work weeks and quite a few on...
sounds like it does not see the unclamp switch
Hook up one axis at a time and move with handwheels to make sure they are counting in right direction. If so, run in test mode to check balance and signal settings,. If you can use meter, check with...
pike,
does it just blank off or act like you turned it off. there was firmware problems with some models about 2 years ago.