I see that Motion carries Bayside, I will stop in there this week and see what I can see.
I just need the pinion, for a NE20-020
Type: Posts; User: kazuo
I see that Motion carries Bayside, I will stop in there this week and see what I can see.
I just need the pinion, for a NE20-020
I recently bought a gearhead on Ebay but it did not come with a pinion gear. Does anyone know where I can find one?
Anyone setup thier tube cutter with a lathe chuck instead of the magnetic friction roller system? The pipe seems to walk back and forth on the rollers and the roller slips.
For now we went with a ghetto fabulous home made solution. We attached a 110 volt drill to the hand adjustable unit that came with our torchmate. Just unbolt the hand wheel, fab a bracket for the...
I am trying to build a cheap manual torch height control for my Torchmate. What I have done is build a bracket to attach a 120v reversable drill to the shaft where the hand wheel was on the original...
Hi everyone, I am looking to add a ATHC to my torchmate2. Anyone want to chime in with what they are using and how it works for them?
I got a quote from Torchmate, they want $2500 for one. Seems a...
Thanks Mike.
When you say ground "the electronics to the table" what do you mean? Run a wire from the metal signal generator box to the table? I am thinking I will run a wire from the PC case...
Hi Mike, I am having some trouble with my Torchmate.
First some history; when I first got it running the signal generator would go offline when ever the plasma torch would ignite ie piercing the...
The signal generator uses a USB. We grounded the plasma cutter chassis and the table to a ground rod driven into the ground outside the shop. None of that worked so we switched out the computer and...
I am having some problems with the torchmate my dad bought. It starts to cut then goes offline. I get a message saying torchmate could not connect to the signal generator and to check connections,...
My dad recently purchased a TM3 and I am giving him a hand getting it set up. Everything is working great except the relay that triggers the plasma to start is not working. I disconnected the wires...