I will do some more photo's and post them.
The plate was drawn in Rhino and the toolpath in Mastercam.
Type: Posts; User: daveelc
I will do some more photo's and post them.
The plate was drawn in Rhino and the toolpath in Mastercam.
Here's a link to a youtube video basically showing the Viper 200's in action on my Hurco MB1 retrofit.
Alot of moves not required but more to proove the Viper's in fast and slow traverse. Running...
Hear,Hear!!!
Any action to protect your interlectual property is a thumbs's up in my book.
People are unbelievable these days.
I bought 4 of the UHU's from Smarbaga and the quality looks...
Kreutz,
Thanks for the offer, that would be much appreciated.
Thanks again!
Dave
Hi
I have been watching the developements here for some time with interest, and as a result and having lower output requirements bought 4 drives off of Smarbaga.
They eventually arrived all...
Have any of you guy's had the MB1 or KMB1 stuck on the language screen.
I can get it to boot this far and then it freezes.
None of the buttons seem to work.
Dave
Do any of you guy's have any circuit diagrams or pin config for the Randtronics drives in an MB1?
Thinking of retro-fitting and just wondering if it's feasable to keep the old drives?
Dave
Got exactly the same problem with my MB1.
I am just about to get the hammer out!!
I think for mine, a retro is on the cards.
Dave
Got an MB1 that's got problems.
It has been sat for a while, haven't had the time to work on it.
Put a new encoder on the other day and cleaned out the carbon dust from the motors, a previous...
I too have been trying to get hold of Skyko.
Emails to [email protected] just bounce back, i'd like to try two of these boards or similar.
Does anybody know of an alternative other than Rutex as...
Hi Guys,
Back again, been playing with the MB1, mainly just getting familiar with things.
Also about to check the motors for carbon dust that may have become dislodged in the move(Thanks...
Hi Guys,
Finally got the Hurco powered up and here is how far I can get:
Load Master Disc and machine will power up.
Manual jog X,Y,Z at any speed no problem, position read out, feed rate...
Hurcojohn,
Just got the machine in place in my shop ( Had to take afew bricks out and raise the roof in the entrance, :D all good fun)
Hoping to power it up later today.
Will post screen...
Hurcojohn,
I should be taking delivery of the machine on FRIDAY when I get it powered up I will post the exact read out.
Thanks
Dave
Thanks Karl,
I,ve been thinking along those lines, just wanted to find out if it's a regular problem and peoples experiences.
The guy that has got the machine has spent so much money on it,...
Hi Guys,
Found a Hurco MB1 that is going cheap but has a problem. I don,t know if any of you have any ideas.
Turn the machine on and it will jog on all axis but the moment you stop it comes up...
MBG,
How about rotational molding, toolings cheap can be fabricated, size not a problem just depends if the molding needs internal accuracy.
Bob,
Have emailed the schematics to your company, hope they help.
Any luck with Metal Meccanica 14SRE molding machine schematics.
Dave
I will dig them out and scan them. Have you got problems with one then? The boards are quite solid on them but the drive transistors fail regular if they are over pulsed. Ended up driving the boards...
Hi Bob,
I have a complete manual on a Series 1. Was control circuitry or main power schematic you wanted. Which No. Boss control, not sure if they are different.
Perhaps you can help me, have...