Can you help me with an error code (Not ready-401) Thanks, Bob Moore
Type: Posts; User: IMMREPAIR
Can you help me with an error code (Not ready-401) Thanks, Bob Moore
Thanks for the input! I tested the rotary encoder with a dual trace oscilloscope and the two outputs are good.
any more ideas will be well taken.
Thanks, Bob Moore
Thanks for the reply, Yes the rotor still has it's magnatizim and is a 6 wire stepper
I need help or ideas about a problem i have with this HAAS 10RTV rotary table.
Some history, The stepper motor shorted out with coolant so i hade the motor rewired and i replaced the drive MOSFETS....
Thanks a lot Guys, I think what you sent me will help a lot.
Yes, I have a problem with the Z axis. I found that the transformer used for the z axis had a shorted primary winding puting out too much voltage and burnt the transistors. I rewound the transformer...
Thanks for your reply. I need the control circuit schematics for the electronic stepping motor control boards. If you have this information it would help a lot. Thanks, Bob
Thanks, i am looking for the electronic schematics, for the CNC series 1 Milling Machine. Thanks,
I am bothered with myself for not asking for electronic circuit board schematics for this machine. If you can send me to the right place it will make my day.
Thanks,
Please help, i am looking for BP Model 1 schematics.
Please help! I am looking for schematics for a Model 1 BP milling machine.
Please help i am looking for schematics for a series 1 BP Milling Machine.