Search:

We used Delmar, but we picked ours up at the port in Los Angeles, CA. They handled everything that was required to get it to the States though. I would check with DHL as already suggested as well.

The 180W RECI tube should be able to cut at that speed, with a 100W RECI we can cut 3/8 inch at 20mm/s. I haven't tried cutting any 3/4 inch on our unit to check the speeds. I will give that t try in...

I don't have a file available. Have you tried a thin coat of clear dish washing liquid on the glass? I have seen it work, but it will be a few days before I can provide an actual test.

We purchased a Redsail X900 100W RECI tube (900x600mm) and it performs really well. They make bigger units including flat beds with power up to 180W. Laser Cutting Machine - Low cost Laser Cutter...

Russ has later videos about checking the beam alignment that makes more sense than the earlier videos, it will make things much easier. You have to think about being parallel to each axis, once you...

If these are 2 runs of the same pattern, then a repeat-ability problem exists. I would check for loose belts, that is to say loose enough for the belt to slip over the pulley teeth. It is also...

That is great service! I am glad to hear that you were able to solve the issue. While the real chillers (like you purchased) are expensive, they are worth it.

It sounds like a possible power supply issue unless there is a loose connection. Sounds to me like a capacitor breaking down in the supply, it can produce a short pulse at nominal power but not...

Could you be a little more specific with the "does not work properly" statement. What does it do. if anything?

Color separation typically refers to the number of colors that the software can recognize as different layers. This in turn allows the assignment of different power levels to each color. In addition,...

You should really look into ways of keeping the temperature down, depending on the quality of your tube it may be able to withstand short duration's at the temperatures you are describing without...

We have a 100W unit that we cut 10mm acrylic at 65% power and 10mm/sec. The numbers you are seeing sound about right. If you just set up your machine; check all the optics and make sure they are...

David from Las Vegas, Nevada, not really new, but set up a new user account. I have a CNC Mill, Laser Cutter, Lathe (manual), along with a host of other machining tools (and a foundry).

It doesn't sound far off. I doubt it is actually a 50W tube, there have been many that have been able to verify that the tubes are typically 40W tubes. You should be able to look at the label on the...