Search:

I recently had all of the machine settings re loaded to my Anilam 1100 control.
Now in metric mode machine is jogging at .2mm .02mm and .002mm this is double the previous settings.Does anyone know...

My problem was that the control would not let me enter any password.I contacted a anilam engineer who said the problem was that the memory was overloaded,I removed a connector from one of the pcb...

I recently had a bios battery chip changed and now need to input the set up information,however the control will not accept the password(Y10)has anyone come acroos this issue.

Hi Luke,I think it is basically that you would choose the ER 16 if you were
perhaps doing finer work or need access against shoulders that would clash
with the bigger dia chucks.
Sam

Thanks for that mfgbydesign,my machine works with encoders on motors
and this problem occurs on all 3 axis so is it more likely to be electrical fault
perhaps non of the servos are being activated.

I run a CNC knee mill when powering up I press the servo button
then trying to move in any axis I get the message lag over max and no response from table movement
can anyone enlighten me on what...