hi,
I did what you proposed, and Remove 20% of each of the two Numbers,
It now gives me the right output!
Thanks!
I’ll dig around a little to see if i understand why X and Y values differ.
Type: Posts; User: Fenrus
hi,
I did what you proposed, and Remove 20% of each of the two Numbers,
It now gives me the right output!
Thanks!
I’ll dig around a little to see if i understand why X and Y values differ.
Stan, thanks for taking the time to comment and give some direction.
really appreciated.
I'll check what happens when I change the settings, hopefully it'll be quite easy to find the right...
Awesome to hear that i'm not alone.
I'm attaching the settings i have in LaserCut53. I guess that the error is here somewhere.
All right,so i've set up my laser to cut a 50x50 mm square.
The final result is 40x40 mm square. 20% less than it's set up in LaserCut53.
The laser is a g weike 3040, and i'm not able to...
Brief update:
Measured plywood i tried to cut, it's more than 4mm thick.
I got some 3,1mm birch ply scraps from dad, it cuts fine with speed 15 and power 85.
Engraved and cut a coaster with...
Dear diary,
I've now set up the Laser with coolant & compressor.
I got the softdog by the previous owner, and installed Lasercut53 + dog driver.
The software works fine - I set the work area...
Right, So i've done a bit of reading on the forum. I should probably have done that before posting.
Here's a short summary of what i've been working on so far:
- I'm going to use pink coolant....
Hi All, i just registered to hopefully get help to get started and perhaps later on share my experience.
A friend of mine was about to move, and he had this G.WEIKE 3040 (40W) Laser in his garage....