Search:

George,

Yes all 3 axis have the same amount of too much movement. One of the cards has "FMDC3 board" marked on it, and another has "SAF BD" marked on it.

The screen says --- Boss 15...

George,

Thank you for the quick reply. I am thinking that the problem is not associated with the mechanical / electrical jog knob because it also moves too far by a factor of about 3...

Hi again,

New Question --- I am trying to access the Yahoo group "V2XT" and have filled out the application, but hothing seems to be happening with the acceptance or rejection process, Can...

Hi folks,
I am working with a very early V2XT # 133. When Jogging any axes with the round jog knob, the readout indicates the axis moves .002" when the axis actualy moves .006". HELP !
...

George,
1, Thanks for the quick reply. That's one of my problems --- I have no diagrams, can you point me to somewhere that I can get them? It has a 386SX processor. The serial # is XT144.
...

Hi all. I would like to attach a probe to my Early V2XT. I believe the software is there because If I turn the probe on A message states that the probe is in contact with something. I am assuming...

Thanks Bloke, I did that with no change, I was thinking of getting new SIMMs I think they are 1meg per pair is that correct for a total of 4 megs? will it take more?

Underthetire, I already have...

Hi, Dave and Bloke

I have an Ultimax 3 with a Max3 multibus and mine will not boot either so I am going to follow along with you guys, (if that is OK) Mine acts a little different than Dave's,...

Hi again

After further analysis, with power off the Z axis will almost move down by itself, and is rather difficult to move up .... I am assuming that the old machine is getting kinda loose!...

Hi All
I have been told that the Z axes rails on my old MB1R Hurco have lost their tension, after looking at things --- it looks like they may be adjustable. Can anyone out there tell me the...

Greg,
I am not sure what gets hot,--- I see no evidence of heat when looking at the boards, The "control head", ( the part where you push the buttons ) I think is OK. The boards I am talking...

Brian,
The parts from the box on the side is what I think I need, I will send $ whenever you say how much. I will "private message" my address to you as soon as I figure out how to do that. I...

Hi Guys,
I have an old MB1R with a multibus Ultimax 3, and version 1.64 software, I am in the process of gathering the necessary hardware to add the "a" axes to my machine, rotary unit, servo...

Hi Guys
I am interested in anything I can get for my Tri-Onics HandyMan, boards, wiring, resistors, transformers, books, paperwork, ANYTHING ! Good or No Good, Burned up or not, I don't care.
...

hey phatfred8

I have been following your project an was wondering if you would want to get rid of the Tri-Onics box that does not work, I have a Handyman that has troubles also and was...

Hi guys---Wow this site is Very Interesting lots of info. I fired up my Ultimax 3, max3 multibuss, 1991 machineing center and the message, ---(security device is invalid of has failed)--- showed up...