i dont think mine is rite not sure but i think i need to swap the coil wires so any who this is whats going on ive got the 2 stage on the retract it pulls back @200 psi slows to 100psi and holds...
Type: Posts; User: travis1
i dont think mine is rite not sure but i think i need to swap the coil wires so any who this is whats going on ive got the 2 stage on the retract it pulls back @200 psi slows to 100psi and holds...
when your in the offset tool geometry page you can go to tool # and hit f2 for X offset center line oh with the tool setter down and indexed to the tool you using
thats why im hear it was the single block plus the G4's
thanx guys hope i can help you all out some time
any addy. on ridgid tapping thats next and a new one for me is a taper pipe tap to hum...
ok hear is what i got it just stops when the chuck opens
(BAR PULL)
G98 G18
G0 T1212
G0 X0
Z-1.235
G1 Z-1.835 F4.0
M11
G1 Z-.48
M10
well i just want to do it for show we had to kick and scream to get a new lathe so i though id write a program just to make it look cool im sure ill loose concentricity but hay who cares if it works...
can you run the tall stock in 2 different positions in the same program?
ive never ran a programmable tall stock before
also im pretty sure M25 is advance what would be the M code for the retract...
im trying to use a bar puller can someone show me what the code would look like? or just tell me what the code for the jaws open and close are i think the rest should be pretty straight up i think...
now im jealous good luck to you
ive been much happier after getting the dnc to work i think we both know yasnac made a big mistake with these controllers ill never have another one
thats it you need to get the air out
first your single block this sounds like you way lube oiler if it has air in the lines it goes into single block to protect it you can check it on your alarm screen it wont come up by its self let me...
Controller is Yasnac MX3. We need to change parameter no. 6021 for drip feed how do i do this