Didn't get anywhere messing with the control parameters, and I'm a little worried about messing up the cards parameters. For now it just looks like I will have to estop the machine whenever it is not...
Type: Posts; User: split141
Didn't get anywhere messing with the control parameters, and I'm a little worried about messing up the cards parameters. For now it just looks like I will have to estop the machine whenever it is not...
Amplifier module is A06B-6111-H006#h550
Would changing any of the regen related parameters help with our situation? I'm guessing any damage to the DC system will not be obvious to the eye.
I...
Yes the braking resistor is getting hot, we've measured it hitting 80 degrees f in 10 mins, didn't want to run the draw any longer then that. Could you tell me where the drive braking circuit is...
Incoming is right around 230V, but if it was spiking above 240V during stopping you're saying that it could prevent it from sensing that?
How does the braking resistor usually get signaled to shut off? Is it going to be a relay, or something of the sort? I see a k7t and a k8t attached to the resistor. Looks like they are located inside...
Morning everyone,
After fixing a bunch of things on this used Kia I picked up, I'm about ready to run. Whenever the spindle is stopped from 1k+ my Phase Perfect PT355 shows an amp draw of 20+...
Morning everyone,
After fixing a bunch of things on this used Kia I picked up, I'm about ready to run. Whenever the spindle is stopped from 1k+ my Phase Perfect PT355 shows an amp draw of 20+...