Search:

Thanks to chrisw for helping with this request.

m10x1mm to 1/8 NPT, male to male. smaller the inside, is better.

High grade hardened steel.


Paypal.

SideWinder key by Picture anyone?.


3d cad this right, i have couple blanks for postal.

i do paypal.

31mm for the 19tooth.

request have changed.!

Waiting answer for a front sprocket 19tooth.!

Then the rear sprocket will have to be measured for fittment to not make pressure to the swinging arm!

275460
275462

Ok i did some Research on the Chains.
this is a 428 Chain
12.7mm Pitch.
8.5mm roller diametre.

275446

275444

Is better to measure the sprocket-delves or the Chain rollers width?

You see the picture imeasure 7,3mm width.

No

275228275230275220
275222275224275226275220275232

I want to have two sprockets made, look at the Picture

The small i like to have enlarged from 14 tooth to 18

And the big i like to have reduced size from 48 tooth to 35

Material is unknown...

Hello,

I have this very expensive 7pin lock but no key, may anyone make me a couple by only having the cylinder shipped around?

I hav eno questions...

Om du tenker på helt vanlig plasma kutter, jeg kjøpte slik for 4 år siden fra kina, kostet 2500,- inkl toll mener jeg å huske.
Funker veldig heftig. Brukt den 100 vis av timer, eneste jeg merket er...

The m10,1.25 inner threads may be in an 90 degrees angle of the M18 threads.

Hello im in need of an machined t-piece
Ive made a simple drawing of the piece.
It has to be something similar to the picture, im adding a 10mm 1.25 banjo fitting to an existing m18,1.5 plug as an...

Thanks that is what i have looked for. would i be able to wire the l297 to a 4 wire outputs for a mach3?

Hello again. Ive searched the google for a solution and come up with this schematic for a l298 & l297,
If this works with mach3 ive have 2x l298 per l297,
Here is a picture....

Yes, ive come to think of if i where to connect the stepper straight to the lpt, does mach3 support that?

Hello,

Im trying to setup a breakout board with mach3.

I have a breakout board and a stepper driver for higher voltages.

The driver is an l298 and has input ENA IN1 IN2 IN3 IN4 ENB,
output ...

Hello,

The instruction manual i have says 2=DIR 3=STEP. thats how i setup mach also why i wired the DIR & STEP as (+) and EN & PU as (-).

Yes, good request. here is a link

Hello,
Figured id wire this driver to a 4wire stepper.
Now the driverboard have a 4 wire output that says this 1-EN, 2-DIR, 3-STEP,
4-COM.

What i guesd of this is that DIR & STEP Is two mains...

Hello,. Im looking for some metal flanges for some hydraulics to be made.
Not big of a deal. about 50x30x10 sizes 3x.

Let me know and i will have drawings in notime.