Sorry about that misunderstanding. This is the deal. I changed our programs to G64 code because it was so much faster. We were cutting parts out of a 4x8 sheet of plywood that would take about 20...
Type: Posts; User: audreys
Sorry about that misunderstanding. This is the deal. I changed our programs to G64 code because it was so much faster. We were cutting parts out of a 4x8 sheet of plywood that would take about 20...
The post processor uses G61. If your saying G9 is normal cutting mode...I could try that. Is that the normal cutting mode?
Hello All,
I have just recently started using the code G64. We always used G61 and our Komo was super slow. We have a lot of nothces and cut outs and it was Horrible to watch it crawl through...
I have a komo VR 804 TT Router with Fanuc OM controller. Battery went dead and lost parameters. I have re-entered the parameters and am clear of any alarms. I am to the point where I need to zero the...