Hello again Mactec
If you see the attached photo of my "interface" you can see it shows the DISP button is my shift key. No matter how many times I press this button the red LED lights above to not...
Type: Posts; User: lx450landcruiser
Hello again Mactec
If you see the attached photo of my "interface" you can see it shows the DISP button is my shift key. No matter how many times I press this button the red LED lights above to not...
Any one?
Hello all
I have a water cooled GDZ-100-4.5 spindle 220V 400Hz 24000rpm spindle and my VFD is a YL620-G-5.5Kw 220V. I have everything running as it should but need to change the disply to show...
Ok so I have created an image to show you how may machine is currently wired.
Additionally I had read a few places that the Shielding only needed to be grounded on one side so it sounds like i...
I will try and take some more pictures of my wiring to reconfirm what your saying. I have scanned and created a PDF of the manual see attached.
Ok to try and start on the same page. I misspoke before The error I get is ER 09 or Power loss -"The frequency converter loses power and phase loss: the single phase and second phase (P00.20) are...
more photos for diagnosing
Any one? At this stage id be willing to venmo $50 to anyone who would be willing work me through this problem
More pages
It seems I can not find much information on the YL620-G VFD I have attached the manual that came with it in hopes someone here can better decipher what setting I should be running
Hi Mactec
Thank you for your help But I seems to be getting an ER 01 code with the setting you gave me. would anyone have any recommendations for me? I have my 220v (three wire) input to the R...
Hi
Any luck with settings? I'm hoping to tinker with the machine this weekend if possible and it seems this is the only thing holding me back at the moment
Thanks again!
14 amps I believe? attached is the sheet I was given (mine is highlighted in yellow)
Thanks again!
The breaker is a 50amp and it is single phase. I am using the same plug I run my welder off (swap out the welder for the cnc)
Thank you for your help!
Hello all
I finally have my new spindle and VFD all wired up but I am unclear as to how to set the setting for the VFD
My current set up is
Water cooled GDZ-100-4.5 spindle 220V 400Hz...
Hi Gerry
What sort of prince range would I be looking at for a decent quality spindle? My concern is I would be retrofitting a seemingly nice and rigid machine with non quality spindle
Hello all first time poster
I recently salvaged a Techno LC+ CNC 4896 from "the scrap yard" I am in the process of trying to bring it back to life as a router (I believe it was used for some...