Search:

attach some lead wheel balancing wieghts to the back of the boring bar as close to the tip as possable. use hose clamps to secure the whieghts if the hole size allows or masking tape if hole is close...

what are you after?

you may need to make it much thicker. even if it is boxed and ribbed on the under side. why not go the whole hog and make an x,y table with dove tails ready for fitting with lead/ball screws would...

your G71 is stock removal in turning i think.
G74 G83 or G83.1 is used for peck drilling in z.
G98 canned cyle initial level return
or G99 r point level return.
G98 G74 Z-25. Q5 R1 F50
or...

from what i can see you are not putting in a feed rate after your G00 move the next G01 should have a feed rate after it. if you G00 and then do another G01 put a feed rate again. it should be...

your feed rate is 0.15 mm/min
it should read F15, F150, F500 etc...

i machined magnesium for around twenty years on a daily basis. here are some tips. take heavy cuts and avoid fine finish cuts. do not let your tool rub or remaine stationary with the tool or work...

thank's, i will do that. len

o.k. so i wire it all in? i,m not familier with this stuff, i have no wireing diagrams. spent most of my life maching stuff. i have a computer and can crank it up, i plug the printer cable in, and?

i'm using mach3 turn.

check this guy's web page again, his email address is changed. try [email protected]

Hi, i am trying to find out what is required to controll my machine. i have the software, stepers, three gecko's and a power supply. what else is needed?