I am going out on a limb here but I am assuming when you say with the lever, that this is an electric swich that switches the contacts around to reverse rotation of the motor. Is it possible that...
Type: Posts; User: cschmidt
I am going out on a limb here but I am assuming when you say with the lever, that this is an electric swich that switches the contacts around to reverse rotation of the motor. Is it possible that...
Elliot
It might be nice to have a rough idea what you are trying to make. Is it the hub for the wheels that you are trying to make or the shell that holds the crank assembly. If it is the wheel...
I think what KIMFAB was saying is lay it down on it's side and there will be two opposite corners touching the ground and the other two corners will be the high corners. Put some blocks under the...
Since my last post here, the keypad went out on my BOSS 9 so I replaced that with another Ajax setup and it is much nicer to use. I could try to snap a couple of photos of what it looks like inside...
I basically agree with Motorsports I have a series 1 with a BOSS 9 control which is still usable but I have a series II with an Ajax retrofit which works much nicer and is much easier to use. So...
I haven't done a lot of milling of anodized aluminum but what I have done has never caused me a problem. I just use standard HSS end mills.
One thing to watch is what alloy of aluminum you are...
One other thing to watch for, most cat 5 cable used for house wiring is solid core so you might not want to use it if there would be a lot of flexing.
Hi all,
I am fairly new to machining, I just purchased a BOSS 9 Bridgeport series 1. As summer is winding down, I am starting to wonder what effects the freezing of the soluble oil might have on...