I have been running a syntec controller for about 8 years now. The first three messages need to be addressed before anything will happen. The hardware limits have been exceeded is in referance to a...
Type: Posts; User: daviddansky
I have been running a syntec controller for about 8 years now. The first three messages need to be addressed before anything will happen. The hardware limits have been exceeded is in referance to a...
Hi everyone i emailed tech support at excitech and got a clear answer in 24 hrs. Can't beat that. I want to post if anyone esle has the problem.
When Y and C axis value are not the same,...
Yes this is the problem that i am having also, but after a tool the tool comes out of the holder to the 2802 stop, and z raises up. After this motion if the tool path dictates a x move it hits. If...
I have changed 2802, the problem is that there isnt enough room between the table and changer to move any further away. I would warn anyone buy a router to go with the 5x10. It takes every inch on...
My tool changed have all been retaught, and that is not the problem. After a tool change the spindle moves away from the rack, and lowers the dust hood. Most of the time it continues with no...
Got the c axis problem solved, and many others. Current issue is with the dust shoe comming down and hitting the other tools in the rack. It has happened when the tool changed, and then went almost...
I have messed with what i beklieve to be the homing stop on the c side of the machine any help on how to reset this. I do not think my gantry is out of square, i think the machine uses the stop to...
I have a 1325c, and after crashing y into neg. stops gently, the c axis and y are not the same i try adjusting the homing sensor for the y axis, but cannot get this to work. Any suggestions
...
I have a 1325c, and after crashing y into neg. stops gently, the c axis and y are not the same i try adjusting the homing sensor for the y axis, but cannot get this to work. Any suggestions
...
Thanks agin to everyone, i now have the machine moving and loading and unloading tools
I would like to know how to change the software limits. I also need some help with posts for...
Hi everyone I have finally got my 1325c powered up, and thanks to all of you I have got it reading english, and made it move.
The problem that i have and have narrowed down is this.
With the z...
Alright im in the same boat also. I got my machine in a week ago, and getting all of the small issues repaired and fixed. I am also clueless on the syntec controller.
David
Im looking for feed back on autocabinets, i know its expensive, but look like great software?
Does anyone know anything about the controller that comes with the SHMS1530C
I think i am about to order an 1325c with tool changer, do any of you have this machine or have you used the syntec controller. Will i need a custom post processer?
thank
david
Hello to everyone, have been lurking for a while, have leasrned more here in a week than two months. Like Kustom i have gone back and forth. I contacted exitech looking for a quote, and to my...