When milling a 3-D part, I set a feed rate in my programming software (say F10). When the program runs in the Seiki mill, Fanuc 11 controller, it changes the feed rate all over the place, sometimes...
Type: Posts; User: gtdinc
When milling a 3-D part, I set a feed rate in my programming software (say F10). When the program runs in the Seiki mill, Fanuc 11 controller, it changes the feed rate all over the place, sometimes...
I am not a machinist or programmer, I am in the IT department in a support position, so I may not know the proper terrminology.
We have a Hitachi-Seiki mill with a Fanuc controller. It is an older...
I have been using SolidWorks since 2000. I have taken many SolidWorks classes. There is no easy way to learn SolidWorks. Classes are the best way, but the tutorials are very good. The VAR you...
Thanks Dan for the excellent information. We have been using 4800 as our baud rate for several years. I tried to change it to 9600, but it did not work. Am I missing something? All I changed was the...
I found out that all I need to do is set the mode switch to tape and send my program. It works! Now we'll see if data starvation is an issue.
Hello,
I am new to this forum. I hope someone can help.
We have a Seiki mill with a Fanuc 11 controller that we feed from a computer via RS232 from the Esprit programming package, using DNC....