Search:

PIC Table 21 (8 - F) Should show the feed rate override. The Feed rate override switch is 18 (D).

Dynapath Wiring
http://www.dynapath.com/pdf/4204123Delta10-20MCP2-LC3AxesWiringDiagram.pdf

If you are replacing with new brushes then very little breakin is required. However if you install old brushes in a new position the brush could ride on a single edge and then rock into more contact...

UGH! If you didn't put the brushes in the same position and rotation they will have to reseat. If the brushes do not fully contact the armature, axis lag will be effected as the brushes wear into...

Are you still having trouble with axis lag on all three axis's?



Is it consistent, .0000 in one direction and .0022 in the other? This would be indicative of an error in signal generation from...

When I purchased My Tree 325 I was unable to erase the existing files. Some of the file name characters were not alphanumeric. In order to erase these files I had to pull the lithium battery.
...

It's evident now that Tree used 2 different tachs on their J325's. If you look at CNCTOOLMAN post TP4(tach) was originally set at 7.9Kohms. When he re-tuned TP4 to 4.4Kohms it made the standing...

The schematic that Redzilla provided best illustrates this.
Given:
Dynapath input signal J2(1 and 2)
Tach input signal J1(3 and 4)

If the tach signal R29 is set too high it over whelm the...

I fear that your machine may be equipped with a different tach. I have provided an alternate tuning procedure on a new thread.
http://www.cnczone.com/forums/tree/307982-software.html

Look for "A...

The document below was downloaded several years ago from the now defunct website www.machinetoolinfo.com.
This post is not Tree specific.

There are a few items that I will add
1. Power supplies...

Is this a Dynapath System 10/20 or a Delta 10/20?






I think your on the right track. The Dynapath controls are creating an overall analog offset that is effecting the balance. If you're...

Go to mode select 5 (setup), key in TM1, Enter (rapid override), set the feed rate override to 1/4 turn from 0. Will G00 execute?

Don't bother with the TM4, E-Stop test. You wouldn't be able to run G01 in position if the Dynapath controller was at fault.

I believe your tach is out of adjustment.
The tach value is a...

Does your program halt at G00 or does it halt after the rapid?
Are there any errors shown when you press fault key?



Having the same axis lag is odd.
Go to mode select 5 (setup), key in TM4...

What happens when you rapid an axis? Are there any error codes?

Your first check is the Dynapath power supply. The power supplies are Dynapath's main weak point. You can check all of the DC outputs with a DVM. First check the DC outputs in the DC...

If this is still an issue I can help.

Mike