Search:

Hi Janos,

Not sure this is the cause or what version you are using, but I know FC is having problems with the 3d simulation. Started in v15 and is still the case in v16. I just talked with my...

It certainly sound like a post issue. What FeatureCAM version are you using? I may have an OM post I can give you. I program OM controls daily. The post I have works well, but more importantly it may...

I have been using FeatureCam for about 4 years now, almost exclusively with SolidWorks models. I have never had the slightest of issues. I am very happy with it.

doug6949,

I have been using FeatureCAM (2 1/2D Turn and Mill) for the about the last 4 years and posts have been no problem. I do believe their post language is well doucumented and easy to...

Wiseco,

I have found I need to set my Z Clearance to the amount of stock I need to face off when using canned cycles.
I always program with Z Zero at the opposite end from what you have. So, if I...

inthedark,

If you have a chance you might want to check the forum out. Alot of posts there on many different subjects. Some are really useful, especially if you do much scripting.

Also, good...

inthedark,

I was just wondering, did you ask your question on the BobCad support forum or only here? I do not recall seeing it there. Seems like they have a couple of users there that might be...

Yeah, Ken I have had that happen a couple of times. I just blame the computer. It's easiest.

Dan

Hello Ken,

I have received the same message about the download and have never downloaded it. I can still get on the site with no problems, however I have never been able to get the site to...

Hello Peter,

Yes. 6000 mm/min. If it were 6000 m/min I was going to ask where I had to get a plane ticket to, to watch that cut.

In a past life I made rock maple supports that had the contour...

Is my math right?
1 m = 100 cm
6000 m/min = 600000 cm/min = 236,200 inches/min?

Try the number again. They switched phone sevice and ended up down for a while but are up now.

1-877-626-1262
1-813-874-2335

WMS,

Thanks for the link. Does this mean OneCNC will soon be supporting 4 and 5 axis?

I would like to thank Mortek for his help with the above subject. Also I would like to thank whoever contacted OneCNC to notify them of my problem.
OneCNC US contacted me and they are now working...

The OneCNC website.

What happened to steve's post on the OneCNC website forum.
I have had the same problem and would have liked to know how his may have been resolved. I was afraid if I posted there it would be...

brtlatjgt,

From what I have been abble to find out both BodCAD and OneCNC shared the same source code once upon a time. From that point they went different directions. I think when OneCNC first...

Rekd,

I only use cutter comp. to adjust for size, so I do have to draw an offset cutter path equal to 1/2 the cutter I am using. There is no type of automatic selection for G41 / G42 but you can...

I am a happy BobCad user. I have used it since version 17. I do both 2D and 3D work. I have not needed to use support for anything other than passwords which they handled very promptly.

With...

brtlatjgt,

I would STONGLY suggest requiring any software vendors to demonstrate programming a part you will be working with. Have them do this for you step by step. Then be sure all the workings...