It sounds as if you do not have resistors between the motor and power supply. This could melt wires and possible damage the board or motor. Get the specs on you motors and power supply and contact...
Type: Posts; User: DTLLC
It sounds as if you do not have resistors between the motor and power supply. This could melt wires and possible damage the board or motor. Get the specs on you motors and power supply and contact...
The DB25RBOB has relays on it and they will not interfere with your logic signals. The relays are turned on and off with devices that have protection from such EMI issues. I have sold many of these...
The 4XCNC10B is capable of driving very large machines like Bridgeport mills 4x8 wood routers ETC... Its only limitation is 10 amp motors so if you can move a machine with a motor and it is 10 amps...
The 4XCNC10B is not a chopper drive it is a L/R drive and needs resistors if you plan on running the motors at more then their rated voltage. I offer free tech help on my products if you need help...
I offer free tech help on my products if you need help e-mail or call me:
David Delagrange, Owner
Delagrange Technology LLC
4024 Fairfield Avenue
Fort Wayne, IN 46807
Phone: (260)...
I offer free tech help on all my products. If you still need help e-mail or call me and I will get you up and running. I want your board to run.
David Delagrange, Owner
Delagrange Technology LLC...
The 4XCNC10B is a very simple and reliable drive board. I offer free Tech help to all via e-mail and phone. There should not be any problems with my drives. If there is please call or e-mail me so we...
Hello,
I think you contacted me on this, the motor spec sheet looks familiar. I will post the answer here just in case and to help others with the same motors.
YEL & BLU Twist together and...
Hi Aaron,
According to Gecko:
http://www.geckodrive.com/photos/G201_REV-5_MANUAL.pdf
The power supply to be used for a chopper drive needs to be 67% of the phase current of the motor this...
Thanks Stuart76 :)
I hope you are having fun with the machine. Mach 2 and Mach 3 will run DTLLC.COM boards without a hitch you do not have to get a microstepping drive. You need to set the pulse...
You can run 10 AMP motors with 60 volts with a DTLLC.COM 4XCNC10B Board and they have relays on them to switch on and of your spindle ETC.. You also get 4 axises of motor control at a very low price....
UMmmmmmmmmmm You can buy 50 watt resistors for $3 - $4 Ea. at :
http://www.mouser.com/index.cfm
The 4XCNC10B will do everything the Hobbycnc board will do and more!
Dave
Set the Minimum Pulse width and Direction Prechange settings under Motor Setup to 5 uSec and you should get smooth running.
Dave
Hi George,
When the motor is not spining the current is steady and at its max flowing through the coils of the motor. This is how you measure the current on this board. When the motor takes steps,...
Hi Guy,
I would be glad to help you get your 4XCNC10B running. Feel free to have a look at my web site first I have additional information on it.If you cannot find what you are looking for e-mail...