thanks for the input . I will swap out my 4th axis drive and see if that helps .TBH I am not sure if they have brushes or not. I can turn the power on with out mach 3 and as soon a I hit my reset...
Type: Posts; User: LEARN
thanks for the input . I will swap out my 4th axis drive and see if that helps .TBH I am not sure if they have brushes or not. I can turn the power on with out mach 3 and as soon a I hit my reset...
Hello I have an IH CNC mill that just started having an issue with Z axis. I started out as a z axis fault so I hit the reset on my machine. ( I have a reset button for each drive built into my...
No network in the garage. I do have an old router but I had no luck trying that
on my mach 3 computer it is windows XP
my other computer is my laptop and it is running windows 8
Depending on what u have and if it's a good price
Yes
Just received an email 25$ so I'll be buying new
- - - Updated - - -
No your spam post does not help
What about the nut on top ?
To the top. I emailed charter oak about a week ago and no response . Send another email last night as well.
Sounds good send me a list of stuff and a price
Hoare you guys running your z axis ball screw oil lines ? Mine goes under my machine and I would have to reroute it some how if I made an enclosure.
I like the over all appearance . But like above wider opening and low side windows that either are removable or slide up
Anyone know where I can find a drawbar ? 1/2-13 thread fir a nmtb spindle
Pm me a list of stuff and prices . I'm always buying tooling
Where are you located
I have been hearing this annoying noise coming from the x axis motor. It's not loud at all but can only hear it when the mill is sitting there at idle. What could be the cause of this ?
The...
I had thus problem when I switched computers . If I remember er correctly I did not have my Mach completely installed. Be sure it is completely installed and you load your xml file I think that's...
I would love to have that eNclosure. I would say 5-6k just guessing
nice work are you using a ball nosed cutter to cut that ?
Wow thanks Jeff
I will post a pic up asap.
278748having issues tying to convert this to DXF through ink scape just need the outlines nothing fancy
Here is a a simple way for anyone to add tool length to their tool table.
Do all the steps below after how establish a z home .
1. Using a 1,2,3 block or any thing that you know the exact size...
I have found that Castrol's Mb50 is the best I have used to date. it is not greasy and it does not get stinky. after 6 months of use I only had to add 3 gallons of coolant to keep the levels at 8 or...
maybe try to run it above the part to see if it looks good before you run it on the part. you will be able to see fit is off that far .
I use Mastercam to design and powermill for cutting
do you have anymore pictures of that indicator holder
we have a Deckel Maho DMU 60 P hi-dyn that we have had nearly 9 months and have yet to get it running . we are now in need of a post or a sample program with the header and end .
we currently use...
No switch it till the axis is reading correctly. Z negative should be going down . Switch hit up if the numbers are getting bigger if you are going down in z
Did you get it figured out . I think you had the settings wrong like I was saying
you need to go to
config
homing/ limits
and reverse the X and Y ( make them red )
Ijust helped a friend a week ago with his mill and it was the exact same issue