Search:

Ah ha, will have to follow up with another config change then also had kinda forgotten about the relay with the progress. That seems pretty straight forward though, and I can always drop back if I...

So close. This time when I went out to check the settings, I powered up the VFD, but let the spindle start and run automatically (I don't want it to do this, but progress!!!) it ran to 6000 rpms then...

Joe2014, Thank you so much for the list of settings and the help you have given, only a few of them I am not comfortable changing, they are noted inline.

I put your image up into a Google doc, I...

I will see how those compare to mine when I get a chance.
That sounds the same as my setup, though I am using a serial cable only, though I should get an ESS Smooth Stepper.

I had some old...

So I just ordered the relay you had recommended to Dekman, other than having to wait for the shipping time, spending another 2.50$ is pretty much nothing compared to what I have in it so far.

I...

I have these two relays, would either of them work?

307866
307864

The electronic side of this project has not gone so great, I am much better at the mechanical end of things.
I do not want...

My PD070 is 0 and 72 is 400
The pulley value is at 24,000
and I am seeing the ~8.X voltage

It seems like I have everything setup correctly, but am missing something somewhere.


I did find...

I have the same setup, and I have mine connected this same way, however I can only get 9.8k RPM from Mach3 control of the spindle. I can get the full 24k when manually controlling it.

Did you get...

I actually have the hot tub and garage on the same main 50amp circuit, but the wires go from my main box to a breaker box that then has the tub and the garage coming out (both on different breakers...

I did change the wiring to be like that, the same error came up, so I disconnected the Spindle to look at the power coming from the VFD when running it while not plugged in I noticed it going up to...

OK, well you have a recommendation for a new VFD? I now have a dead VFD for sure....just trips the breaker and has been cooked.

Oh I got it. so the neutral is now not connected, still the same results though.

Ok so a little confused. I am running 220 I thought that I would need two 110 lines and a neutral and ground?

So am I supposed to connect both 110 hots to one one terminal?

I extended the...

The spindle does turn freely, and will run at 4500 rpm with my settings from the original post.

1-2 = 1.2 ohm
1-3 = 0.5 ohm
2-3 = 1.3 ohm

None of the 1-3 pins are grounded, though neither is...

Well that is not good, the fourth pin is not grounded to the body of the spindle. I ran a temporary wire from the spindle to the ground on the VFD, same place the ground wire connects.

For testing...

So it looks like the only thing that you listed as changed is PD007 from my factory .5 to 20. seems quite high


Originally I had started with a factory reset, then just changed the basics 1-11 ,...

I bought a 2.2KW spindle and VFD from ebay it is a 220v water cooled version. it says it is 2.2kw 220v 8.5 amps

I have been trying to get it working, but cannot seem to find the correct settings....