My lathe is no longer doing c axis contouring. The c axis will jog in manual just fine, but when running a program, it will load up to 163% and alarm out. I have ran 3-4 programs cutting a square end...
Type: Posts; User: Cris_co
My lathe is no longer doing c axis contouring. The c axis will jog in manual just fine, but when running a program, it will load up to 163% and alarm out. I have ran 3-4 programs cutting a square end...
I’m pretty sure the system link button works, the lathe will alarm out if you push it and the bar feeder isn’t powered up. If the bar feeder is powered up, the button will light up, but the feeder is...
I do know when the e stop is pushed on the bar feeder controller it will alarm out the lathe.
I’m trying to get my bar feeder running, and I have an “emergency stop line open” on the feeder control. All the safety switches will give their own alarm pop up, so I believe they are all closed....
When you say card rack do you mean the whole row of big boards? I pulled all 3 ram cards off and reseated them
My mcv4020 w/ osp u10M started having issues booting up, I’d turn it on and off once or twice and it would work, then I started getting the cpu bus alarm, I pulled the board out and the ram cards and...
I just got an l370mw, and the cooling fans always run on the hydraulic units, even when it’s in power save mode. My mcv4020 shuts everything off when in power save mode. Is there some parameter that...
It’s on a L370mw - osp e100L - it runs fine without it. I wish I could find out what to change on the post to have it not in there
Wondering what this code is, fusion 360 outputs, but my machine doesn’t recognize it, I can delete and the program runs. Haven’t found that code in a list yet.
I saw there is a pin to depress on the pivot
I have just got an okuma l370mw w ospe100L - I tried both okuma lathe posts and managed to get them turning by modifying a few lines. I have been using fusion w my mcv4020 mill for some time now and...
I just got an l370mw w e100l control, but no manuals. Does the tool setter arm just pull down or is there something I need to do to get it down? I kind of pulled on it and it did not want to move...
Update if it helps, I found out how to manually move the magazine and tool change arm, I set them where I could push the pin back and forth, zeroed ma/ts, and still had issues with the ts actual...
My first thing was to clean all the prox switches - I thought that fixed it but not. I noticed when you look at the actual position of the TS when the tool change stalls out it will be either...
I saw that in the manual - not sure how to go about fixing it though
Also, I noticed the actual position on the TS axis does not go back to zero when the error occurs. It will be .095-.12
New member, longtime forum browser. I have a 1999-2000ish okuma mv4020 w/ u10m controller that I acquired a few months ago, and recently have started having issues with the tool change stalling out...
New member, longtime forum browser. I have a 1999-2000ish okuma mv4020 w/ u10m controller that I acquired a few months ago, and recently have started having issues with the tool change stalling out...