Search:

Thanks Al

Yes I know there is the AMP enable on the 2900 I could run it active low or High I have the chips to go either way.
But how would I hook it up to the G210?

I really do not...

Hi Guys,

After years of production and 3 years of My machinery in storage I am setting up shop again.

I am setting up a 3 axis mill with the following.

Galil 1830 PCI + ICM2900 + G210 +...

Nothing in life is a certainty.
Of course you need to do testing.
Some MFG also recommend to try closing the point contact gap on the Tig.

I was in a situation were when I was welding a...

I know this a old thread , but I know how to solve your problem.
I had the same problem.

You need to put the Tig machine on a ground all by itself.
Drill a hole thru the wall of your garage not...

Thanks Roy,

Did you wire those up in serial or parallel?

How do you like Mach3?
Was it easy to setup?
Any downside to it?

I thought about switching to Mach3. It would be nice not to have...

Hey Guys,

Does anybody make a decent stepper motor to use with the g210
that is suitable for bridgeport series 1 cnc machine?

I would like to have 100 ipm rapids.

Thanks,
Joe

Can the disable signal be run through a limit switch?

And if so can it be in series with the ground signal from the
controller so that I can still use my e-stop switch to disable
all axis.

I...

Thanks Gerry,

So it will not possibly cause damage to the drive?

Thanks,
Joe

Hi Folks,

I have a stepper motor that is rated for 8.1 amps.

Would I get ok performance using the G210.

Thanks,
Bubba