Search:

I do not believe there is a simple way to do in versions enroute without 3D enabled, as that sounds like a job for enroute's 3d options:
where you would clamp your panels with a jig to the table,...

quick follow-up on resolution... major brainfart
I originally mirror'd the dip switch to the existing/failed board, BUT I didn't notice the adjacent pin jumps weren't set to multicam's design.
...

Stepper control board arc'd & died, easy replacement with a PacSci 6410-001-n-n-n as I've done in the past BUT now that i've installed a new one, the z-axis stops about 4 inches short of the...

that keypad emulator doesn't work for the 3000 series. I've been down that path before with multicam service techs and it just ends with disappointment.

i'd dropped these keypads and they're...

you mean the hollow steel base with bits of foam in it? Ya its just a muffler. That whole rig is just a simple housing for the blower, motor, airfilters & electrical.

shuddering motor could also be coming from an overheating control board. you could swap the connections in your electrical cabinet between the Xa & Xb and see if the shuddering follows the swap. ...

you shouldn't have to send a partial file to complete when the machine errors. there is a built-in "proximity start" option by moving your bit above the last point you left off and hitting...

i just had same error, resolved by servicing the ABB contactor near the control boards in the cabinet. it was stuck in the contact position even when powered-down.

same issue, "motor fault Xa, Y, Z" upon startup.

figured I'd chime-in, that my fix was the ABB contact near the servos was stuck in the "contact" position even when machine powered down....