If TNC415B has lost its parameters from RAM due to flat battery should the machine start up from EPROM.?
I think MP4010 = 1 ... was set so as to startup from RAM.
Do I need to change MP4010 to 0...
Type: Posts; User: Pokeman1
If TNC415B has lost its parameters from RAM due to flat battery should the machine start up from EPROM.?
I think MP4010 = 1 ... was set so as to startup from RAM.
Do I need to change MP4010 to 0...
This is actual screen dump (attached) showing the error code when the problem occurred.
"PROCESSOR CHECK ERROR 1 M"
Manual says this is operating voltage out of range.
Question..... Does this...
OR..... does anyone have a manual that shows the block wiring of the board that the 12 PIN plug plugs into......ie assume the NC board itself
Question is... what does PIN7 plug in to and connect...
Hi, Has anyone experience of the TNC 415 .... and the NC Power Supply.
The machine stops with a error of the type "unstable power supply"
All the lights are on the NC supply board OK but the...
That is why in Post #7 above I posted the link to the Windows PC options, but it must not have been read yet, and also read the user manual......RTFM.
Yes, all very good advice, but to go back to jort68 original post.....
jort68 was given a cnc 3040 Z DQ that has only a parallel port input. This is meant to be plugged into a parallel port of a...
Read these pages
https://rckeith.co.uk/mach3-parallel-port/
The question is why does it not work.?
Do the drivers install correctly and show up as LPT port in Device manager at 0x378
Does the software install correctly on Mac Laptop.??
Mach3 website...
Your video shows it working from a USB port, has your machine not got a USB as well as Parallel.
Options are
Buy a good quality USB to 25 pin parallel adaptor lead one that does the proper IBM PC...
What is the Error code ...??. Where is it showing up.?? What is the last thing the machine is doing when the error comes up.??
Fagor 800T was working, then battery flat, now replaced, now won't move.
Get error 99 Parity error M table..??
Think that means codes missing or corrupted.
I can display codes but have nothing to...