I have an interesting problem; I have been doing the Auto PID for the X and Y axes and have moved on to doing the Z axis.
I was setting the PPR as I have done on the other axes.
When I move...
Type: Posts; User: mcdrury
I have an interesting problem; I have been doing the Auto PID for the X and Y axes and have moved on to doing the Z axis.
I was setting the PPR as I have done on the other axes.
When I move...
Hi,
I have a machine with Yaskawa Sigma II SGDH 15 Drives.
The servos and servo drives run as I ran a test with only the servo and servo drive connected to each other asper the Yaskawa...
G'day all,
When setting up the Limits and Homing, specifically soft limits in Mach 3, I had the last 25mm before "0" home, travelling at 20% of nominal speed.
How do I achieve the same in...
G'day all,
When setting up the Limits and Homing, specifically soft limits in Mach 3, I had the last 25mm before "0" home, travelling at 20% of nominal speed.
How do I achieve the same in...
No probs. I'll try there. Thanks
Ramon
Oops. Try again.
Windows 7 32
I added the parallel port 2 weeks ago as the PC wasn't built with one.
Screenshot attached.
Hi Doorknob,
Further to that those earlier pin combinations show 0V when Mach3 is closed down.
Thanks
Ramon
Hi Doorknob,
Checked pins 2/25 and 3/25 on parallel port and they're reading a constant 5V.
Jogging Mach3 has no effect.
Mach 3 holding pulling the voltage up?
Thanks
Ramon
Hi Doorknob.
Thanks for the reply.
I have a consistent voltage of 4.8V at 8-10 and on 9-10 at all times; when jogging + or - and static. Hmmm.
Thanks
Ramon
Hi all,
I have a problem with a set up that consist of the the following gear;
G203V
Nema 34 - 640oz/in
MB-03 V1 BOB
All seems to be wired correctly, and the motor holds but wont turn when...