Search:

I think that i have narrowed the problem down to the transmission, I can feel play when manually turning the spindle back and forth that seems about the distance of the oscillation. then checked all...

Thank you,
I gave that a check and tightened it up but it did not resolve the issue.
I was looking at other threads and think it could be the spindle gain, does that sound like the next step? The...

Hello,

I have an issue on a new to us 1995 Bridgeport Tor Cut 22 where the spindle oscillates when doing a spindle orient and tool change operation, which can cause some issues with changing...

I am working on finishing my retrofit and have come across an issue. The mesa 7i33 outputs the +-10v analog signal on one pin and the AMC drive has analog + input on 1 pin and analog - on another...

Was a post processor ever produced for EMC2, I also need it.

Thanks, I called up Antek and ordered the supply that he recommended. I have only one more question for the time being, Will I see any problems mounting the computer, drives and vfd within the same...

Any idea where i can get a similar rated transformer in the US, I have checked Grainger, digikey, and newark?

Ok, That transformer is definitely too large for the amps I have then. Just as I thought I was figuring it out. One more probably stupid question, can I combine the secondaries like the primaries to...

I have been looking at another transformer that would get me closer to the amperage and volts I need to run the new drives as effective as possible. Is this transformer sufficient:...

Ok, I will try the original power supply and see how it works. One other question, why would there be a transformer between the servo amp and the servo. In the picture the + and - from the card go...

Yes, I still have the original power supply in working condition. Is there a way to change the output voltage to what i need? i just assumed that I would get the most benefit by getting a power...

I am new to the servo thing, I have a stepper driven machine, but have always been confused by the power supplies so I just get what the drive manufacturer suggested. I don't have that luxury with...

The drives that originally came with the system are servo dynamics sd1525, these drives were being supplied 72 vdc. What would be an acceptable size power supply to run the amc setup? Correct me If I...

I am converting a Milltronics Partner IV to EMC2 and need helping figuring out what power supply I need.

The servos are IIC
27lbin
3700 rpm
141 volt
47 pulse amp.

I am going to use...