Your welcome.
Search:
Type: Posts; User: visioneng
Search: Search took 0.00 seconds.
-
04-29-2019, 04:45 PM
- Replies
- 3
- Views
- 1,011
-
04-29-2019, 04:33 PM
- Replies
- 3
- Views
- 1,011
Re: Vision 2550 routing table with series 3 contoller, need z axis microstepping sett
Hello,
The correct resolution settings for the Vision series 3 controller are below:
X: 3 off
Y: 3 off
Z: 1,2 off
Thanks,
Joe -
05-24-2010, 03:22 PM
Thread: horizon (vision) engraver
by visioneng- Replies
- 5
- Views
- 2,356
That controller was made by Engraving Systems...
That controller was made by Engraving Systems Support in Dade City Florida. Their website is http://www.engravingsys.com/ and they should be able to help you with the Horizon controller.
-
05-21-2010, 03:50 PM
Thread: horizon (vision) engraver
by visioneng- Replies
- 5
- Views
- 2,356
You are correct, that is the plug for the spindle...
You are correct, that is the plug for the spindle motor. It required 0-90 volts DC power. Vision can sell you just the 90 volt speed control board for $179. The part number is 503500-00.
-
03-02-2010, 03:21 PM
- Replies
- 2
- Views
- 980
If you have Vision Pro version 7 or 8, you should...
If you have Vision Pro version 7 or 8, you should be able to run it. Run the Vision Pro open drivers program from within the Open Drivers folder on the Vision Pro installation CD and select the...
Results 1 to 5 of 5
