???????
Any help would be appreciated
Type: Posts; User: rstiverson
???????
Any help would be appreciated
Does anybody know if this can even be done?
Is there any way to change the hard disk and floppy disk drive letters on a Sodick A325/Mark 25?
I bought a usb drive to replace the floppy, but from what I can tell it needs to be assigned drive...
I have a Sodick A325 with Mark 25 controls. When I start the machine up it always starts with the cutting condition at C100. Is there any way to have it start up with the CC at C777?
Thank You,...
I am using .010 brass wire, good flushing, and I cleaned and indexed the carbide contacts.
When I was checking the discharge cables, one of the ends pulled off. I repaired that one, and ordered...
I cleaned all cable connections and connections on the rails, cleaned and indexed carbide contacts - still only .025 to .030"/min.
I have a Sodick A325 that seems to burn slow. Ex: If I cut a 4 inch piece of steel using the cutting conditions from the manual it wants to set the feed rate at 0010(.100 in./min.). However it is...
I did have some wire wrapped around one of the drive rollers. I got that out, but it didn't help. It is the belt type AWT. 85 Pipe AWT.
I also started messing around with some of the settings...
When I use the AWT on my machine it feeds the wire all the way through to the feed rollers in the back of the machine. The problem is the machine does not recognize that it is fed through, and tries...