Fantastic! Glad the group was able to help out
Type: Posts; User: hh8m
Fantastic! Glad the group was able to help out
Good News! Keep us posted.
alll the best, Henry
Rosalio -
How is it going any progress?
Henry
Just thought of something else - you mentioned you got half way through the program... make sure you turn off the windows screen saver - it can cause issues.
Glad your making progress..
All the...
I would try a desktop before you gave up and retrofitted. My choice would be an XP machine. Make sure it has parallel and serial ports.
All the best, Henry
Wait a minute another thought - have you been trying to run the PLM2000 from a laptop now? This could be part of your issue. I am not an authority but I understand laptops can create issues running...
Rosalio,
Good! You are running the program! If you are getting a fault for the switch during a program - you are ok, it is working you just need to find the switch wire and follow it back - it...
If you have communication and it is stopping on the shield error you are almost there! looking at the machine from the front there is a switch (grey block) at the end of the X axis in front of the...
The only things I can come up with are:
Check all fuses - including the one inside the back cover on top of the animatics controller box.
Your comm port is not configured correctly
I am...
yes - when you are in the PLM2000 directory in DOS type "setup" and answer the questions.
All the best, Henry
Rosalio,
Not sure if you Re-ran the setup program for PLM2000 to configure the port etc.
Are you positive your parallel port is ok?
All the best, Henry
Keep us posted - Henry
IF you are running windows -
3) DOSBox0.72-win32-installer.exe - 1258638 3796826 i386
Should do the trick.
all the best, Henry
When you are in the DOS window there is a "prompt" it is usually a "C:\>" if there is something after the C:\"XXXXXX" you need to get back to "C:\>" At the blinking prompt type "CD.." (CD period...
In Windows XP you need to open a DOS window (command prompt). Then navigate with DOS commands to the PLM directory then run the PLM2000program. The PLM program will open in an expanded window.
...
jskene -
You are correct - I looked over the basics. DOS is a must.
Henry
Rosalio
You mentioned com port 0/0 I think you need to be on one or two. Double check your comm port settings and re run the set up program and choose the corrospoinding port.
Make sure you...
Rosalio -
Check -
Fuses are all OK.
Your parallel port (for tool changer) and serial port is set up and communicating properly in your computer.
The Prolight software has been set up...
Tom,
Remove the allen screw at the bottom and the black ring (read large washer) will come off. Slide the slitting saw on the arbor, replace the black ring and tighten Allen screw.
All the best,...
Mark,
I just purchased a Prolight 2000 and planning the same retrofit of controller you are.
please keep us informed on your progress I am ok at the machine part part not good at the...