Search:

CNC Router Parts 5'x5' Similar Router

New CNC Router Parts 5'x5' CNC Router. Actual cutting dimensions are 52"x56"x9". I have made a few upgrades in the design process to improve over the standard...

Spindle plate says 40*C or 104*F but like I said, it is quite warm here.

Maybe I didn't notice it over the winter but my air-cooled Perske 2.2kw spindle is getting quite warm. I am running it at 18,000 rpm and the fan atop the spindle is moving a good amount of air with...

Poles are set to 2. Max hz now set to 360. Deceleration is what ever factory setting is and it seems to be working great.

When I try to set 1-05 to 300, I get an error. 1-05 is minimum output...

Ok I've gone through and reset everything to factory settings and used the single phase plate settings. It hasn't tripped yet. Any ways to really test it before I start a cut job?

I've adjusted...

220v input.

So I noticed something. This spindle has two info plates. See pictures. Is this typical? Which one should I follow?

Specs for both name plates:

info plate #1:

Perske
3~Mot

I have replaced my old Delta VFD-A with a Delta VFD-B due to the main board going bad. Since the main board went bad, I am unable to pull my parameters from the old VFD. I've set up the new one the...

Thanks everyone. Funny, they are located in Raleigh about 45 minutes away from me. I spoke with Joe and he confirmed the control board on the VFD is dead. I ordered the same model again and it will...

Hello everyone,

I am having issues with my spindle. I am running a Perske 3hp spindle on 220v using a Delta VFD-A 220v 2.2Kw VFD. The VFD is reading 8.8.8.8.8. with all lights red when turned on....

I have 5 Moog Servo motors that I'd like to identify. All model #s are worn off except 1. The one intact is 303-029a. I don't believe all 5 are the same motors though which is why I'm posting this.
...

Updated add to lower price

http://bit.ly/1riH7c1

Thanks. I updated to freight or local pickup.

I have my eye on an industrial 4'x8' router I'd like to get funds for.

http://bit.ly/1riH7c1

Hey everyone, I haven't posted much on here but I hope my ebay feedback speaks for itself.

Let me know if you have any questions. Thank you.

Here is the add:

4 8ft 1" Thomson Linear Round...

Hi! I'm located in Burlington, NC about an hour from Raleigh. I have a 4'x8' router that I am just getting set up. I'd love to talk spindle ideas and software. I don't have either yet so I could use...

I found an older AXYZ router for sale. The seller says it's about 20 years old. I have not been able to find a model number or year of production.

Does anybody have any information on this...