There is no driver for tool path to run the rs485 in win 7. You need to buy a new rs485 that is win 7 ready. Yes I know that this thread is very old.
Type: Posts; User: ftptorrent
There is no driver for tool path to run the rs485 in win 7. You need to buy a new rs485 that is win 7 ready. Yes I know that this thread is very old.
If you do a F29, keep pushing the enter key till you see SPINDLE WIRING. What does it say? STD, EMOP, Tach or modbus? Just an FYI the AMC system that you have will ignore the spindle RPM. All...
They are both the same resistor Yellow Brown Black
If they are badly burnt you might want to reinforce the traces as well with solder.
One last thing.....if you're using toolpath, make sure in the Output menu you have REVERSE under Machining Path and not FORWARD. Good luck.
The Camtech lasers were never made with an enclosure to ventilate. Usually it was the customer that housed the laser in a room with a fan ventilating to the outside. Depending on the material you...
What seems to be the problem with your laser?
Its Brown Black Brown.
Sharp, send me a PM with an email address. I might be able to help you. I just don't know how to upload things here.
Yes plug it in and turn on the computer should be good to go.
It should be a black ASI slot. Are you sure it is not 2 slots side by side? As long as the slot is black you should be ok.
It is simple plug in and go. Make sure you have the jumpers set for PORT 3. Simply plug it in and make sure that in ToolPath you have selected LRC-3. No drivers needed.
FTP
The 20 amp fuse that you are replacing sounds like it is on the connection board on the left located near the bottom right but on that board. If it is blowing often, take a look at the traces on the...