Search:

Guys,
Was pulling apart my mini mill do some cleanup and adjustments and found a problem with the X Axis gib. It is not aligned correctly with the dovetail on the table. Have not noticed it...

I leave it disconnected for now, the 381oz stepper does not seem to have a problem moving the head. I was seeing inconsistent backlash numbers with it connected, was not a linear as all. So left it...

I think someone else mentioned taper pins, I just put in a few of these in another application on the tail wheel of my airplane. And boy does it work well. You need to get the correct tapered...

Guys,
I enlarged the hole on the oposite side where the quill handle passed through. Makes it easier to make sure that bold is tight even with the head down. Put the long end in and grab it with...

Robert,
That sounds like a viable work around. For sure would not expect it to automatically try to figure this out. Was just thinking a future change would all the user to specify a different...

I did not upload the toolpath settings I was using previously.
I double checked them and they do specify the Machine Geometry.
What happens in the waterline path ends up cutting way deeper than is...

The email I sent through your web site was a few months ago.
I uploaded a project that causes the software to full on crash.
Have not heard back.
Not sure I still have the project that causes the...

Has anybody had any luck getting support from GRZ?
I paid for my license but absolutely no luck getting any support.
Have emailed the company on there web site, posted messages here all with no...

Guys,
I have a very asymmetrical part that I have setup to mill both sides.
When setting the cut depth to make sure all features are milled for one sides creates a lot of air cutting when doing...