Hi!
We bought an old Robocut machine and I have a problem..
If I like to use work coordinates, I do like this: Make a pickup to find my origin on the workpiece/ zero the relative coordinates/...
Type: Posts; User: MoraTradgnist
Hi!
We bought an old Robocut machine and I have a problem..
If I like to use work coordinates, I do like this: Make a pickup to find my origin on the workpiece/ zero the relative coordinates/...
Nevermind, It's running now! I just left it connected to power for a few days and now it starts just fine. Bad battery I guess.
Hi,
I have a Mitsubishi 90SZ that will not start after moving it to my new shop. The machine started just perfectly before moving it, now I get servo alarm 017 OR 033.
The feeling is that it has...
Thanks again!
Now the atc works perfectly! I adjusted the arm a few (~5) mm at the end.
More questions;
How do i set my work offsets the best way?
X and Y is no problem but Z... as I...
Thanks for the fast reply!
One of the claws was, as you said, bent. It helped a lot to straight it out but it still drops tools sometimes.
It seems like the arm is out of rotation alignment. If...
Hi again,
I bought the machine and so far everything seems to work properly, except for the ATC arm.
The seller told me that it was dropping the tool during tool change from time to time and he...
Hi!
I'm (maybe..) about to buy a Mori Seiki MV-40M -94, Fanuc OM-C, 10000 rpm option, 30 tool ATC option.
Is this a good machine? Are there any weak points to be aware of?
Can I do some...
Hi again,
Forget about it, I found the sensor for the spindle RPM. I cleaned it up a bit and now it seems to work again.
/ Rikard
Hi,
My old Mikron (TNC 155) says "spindeldrehzahl uberwachung" and I think there are some sort of tachometer or encoder that is broken. Does anyone know where to look for it?
/ Rikard
Hi,
I am trying to dripfeed my Mikron w. TNC 155 from my Acer laptop, with poor results...
Since the computer don't have a serial port I bought a cardbus adapterDeLOCK > Products > PCMCIA >...
I'ts 14" colour. I tried one of these:Video Converters - CGA/EGA/YUV to VGA Arcade HD-Converter PCB (GBS-8220) - JAMMABOARDS.COM - JAMMA Coin-Op Arcade Game Parts - CGA/EGA/YUV to VGA Arcade...
There are replacement monitors available, here: Replacement monitors Agie for example but they are quite expensive. I have been trying to replace the CRT on my old AC100 with an standard monitor of...
Hello,
This is to be set in the events, at the machine level. I think that there is an event called "behaviour at wire break" or something like that and there should be a lot of options there. The...