Ok so I finished up the enclosure a little bit back. Just now getting to update here. I decided to go with a curtain system instead of Plexiglas. It actually gives me a lot more room to get...
Type: Posts; User: Siddhi
Ok so I finished up the enclosure a little bit back. Just now getting to update here. I decided to go with a curtain system instead of Plexiglas. It actually gives me a lot more room to get...
Happy New Year everyone!
Sorry for the delay in posting. With the new year and Christmas I have been busy with the family. I did get a little bit done. I got the lower flange completely built...
Oh yeah that sucks. I did build it where the table runs all the way to the side. It only has about 2" from the side wall and It goes all the way down. I ran it each side and down to the extremes...
I plan to use some pieces of extrusion I have laying around. The channels that are cut it in are 1/4" so I plan to put some 1/4 Plexiglas in the channel and they should just slide freely. I have...
Got a little more work done on the enclosure. I used a piece of 6" flat bar and made a patch for the front. Used some 3/8" carriage bolts and lock nuts....
I put a board on the front to hold everything together. The width is about 4" longer than 8'. So I am going to have to find a longer piece of plywood (which I don't think there is locally), or I...
Hi,
So I decided to make a post about my mill enclosure build. I have been scouring the internet for help/ideas on enclosure builds for some time now. I found a lot for the smaller desktop...
Ok thanks. I know which limits you are talking about.
How do I setup the soft limits?
Ah that makes a lot of sense. Thanks for explaining that for me. I will look into those settings. I think what I did was cheat it with my M6Start file and I told it to stay below where it was...
Thanks for your help Mactec54. I got it figured out. It had to do with some settings that were set under the settings tab for tool changes and I had to create a custom M6Start.m1s file. Now...
Thanks for the reply. I did get everything working on mine. I found someone that had wrote a custom M6start.m1s file and I modified it. Now everything works as it should. Took some playing with...
Yes my home is all zero in my DRO and everything else is negative at that point. I am only touching off on my soft jaw cause I am trying to setup for production in the future. So I need one fixed...
Mactec54 thanks for the reply. I am not sure how else to change this. Here is the process I use to setup everything.
My tool offsets in my library
1. I took all tools out of the spindle and...
Hi everyone,
I am pretty new to CNCing, just to get that out of the way to start with. I have spent the last month getting to know the lingo and what does what, so please bare with me a little. I...