Search:

Dear all,

I run a short program: drill a 0.5" hole, and the next tool is #4 ( 0.250" EM Finish 5 flutes ) to open that hole to 0.515" with G41 code in program.

The first tool (Drill) is OK

...

Underthetire:

Last night, I copied M160 command from row #2, pasted to the end of another program and ran in TAP Mode.
The first was OK but machine stopped when beginning row #2 with an Alarm...

Oddly, They made that door for what while it is not used ???
Does anyone think so?

Actually, in some jobs, a cycle time is very short while setting up requires long time. I have to wait.
Thank you.

243160

I hope you can read it.
Thanks.

My machine is stuck on toolchange with arm at 75 degrees and with toolcup in magazine pos. Prior to it getting stuck i recived a ATC alarm from a m06

You mean after finishing a tool, program goes...

Manual mode, door unlock button

I tried last night already and could not do it.
Machine was running a program in TAPE Mode and whenever I tried to hit or activate other buttons, it stopped right...

When I run OKK 550 Vertical Mill, I can set up tools for the next job by calling old tools and changing new tools at its side door.
But I can not open the side door and rotate tool change magazine...

underthetire:

Thanks for your advise, I just peeped the way they fix this problem, perhaps there is a few omissions that I have not seen clear.
Now I usually make the arm down to clean up chip...

It appears as this only happens after machine has sat a while. Has anyone ever experienced this same problem???

I am not sure ab mh type, for NV 5000 vertical, I see maintenance do as follow:
...

If thats the case, try copying the APC macro and pasting it in the user memory area. Let us know.

underthetire,

Do you mean I need to copy these commands in M160 and paste into the end of a...

I really don't understand what you mean.
Normally, when finishing a program, I use MDI > M160 to manual change the pallets
Some time, I have to enter to Setting page to manually change pallets when...

MDI > M160 to change Pallet when finishing a program.
You might try by M60 as follow:

M0, M1, M2, M30, M60: Program Stopping and Ending | smithy.com

Good luck

underthetire,

My machine has the same problem, but just only after tapping ( 3/4 UNC thread )
The 3/4 tap stuck on the way going back to TCM when the shuttle door on top had opened.
I have to...

I am not sure the NV5000 1A/50 ( Vertical Mill ) is the same of your or not, try this by manually:
Hit Setting Soft Key to find APC ( Auto Pallet Change _ and try the list of function on it:
For...

Go to WCS at the bottom of screen > View Manager > Select which color you want to.
I use Mcam X5

I am learning M5 and only use this way, can not find the other way, tks.