If you have a Fagor control and the engraving add on is installed & activated and you have forgotten how to use it OR it is set up on the control and you don't know how to operate it, I have the 2...
Type: Posts; User: PirateMachinist
If you have a Fagor control and the engraving add on is installed & activated and you have forgotten how to use it OR it is set up on the control and you don't know how to operate it, I have the 2...
I no longer have access to this item. Sorry.
After having to re-calibrate the toolsetter on our 2014 ST-30 a few times now using both the 2012 and 2014 manual, I got a quick, simple and accurate method from a Technician and wanted to share it...
Hauni-Blohm HFS-12 grinder
Hello, we just got one of these in our shop this week. Until today I didn't even know the model they had bought. Is there anyone that can pass along some advise, we have...
This is the only manual I have in PDF format.
Contact me at work as I now have an E-mail address there.
[email protected]
I can E-mail the PDF manual I have to you from there.
Big break through this morning. There is a button on the control with a picture of the Tool Presetter on it! DUH! Set machine in handle jog, drop the arm, press the PSM button and BAM! Offset...
OK, I think I have a handle on my problem. When I tried to get the machine to run a simple program I wrote, it did not go where I told it to go. This put me off with it. Now after much reading and...
Yes, it is retracted.
If I pull the arm down in any mode other than OFFSET the ALARM2? lights up.
Hitting reset makes it go away. Tells me its trying to work.
Touching tools off on it still...
I have a GF2-62075E/04 Dated MAY 1998 Maintanance Manual for the Fanuc 15/150 Model B in PDF.
If you would like a copy contact me @ [email protected]
It is 1.4 meg in size.
I'll send it...
OK, checked button under the tool setter arm. It must have been stuck because the ALARM 2 ? lights up now when the arm is pulled down.
The screen does not change to the tool offset page but the...
Does anyone have a line on a manual for a Fanuc 10T. Paper or PDF.
Thanks in advance.
Thanks. I read in here the limit switch is in the area where the small lock for the arm is located. I'll check that Monday.
Is there a parameter that needs to be set for the probe to work?
...
New here, first post. I've been in the trade 14 years and worked with Haas mills & lathes also Cincinnati CNC's and Okuma lathes.
I just took a job at a place that has an AL-2 with a probe or...