I am so close to having this machine back up and running, but I still need some help from someone
with more knowledge and experience with the 0-MC controller. I got a good copy of the macros for...
Type: Posts; User: Reddrock
I am so close to having this machine back up and running, but I still need some help from someone
with more knowledge and experience with the 0-MC controller. I got a good copy of the macros for...
Thanks for all your help. I have the mill up and mostly working now. I will need to output the parameters to the PC once I have a few more things resolved so I will have a good working copy. I...
Thanks SteveCNC1069,
I got very knowledgeable help from this forum that enabled me to get the machine up so I could input parameters, and I had
to stop working on it to get a bunch of work out...
Thanks tc49, zavateandu and Al, you helped steer me toward fixing my problem. I did pull off the M1 cable
from the I/O board and the controller came up in MDI, allowing me to input param 901, then...
Thanks to each of you that have offered some help. I appreciate it very much.
I will get into the machine later today and will post the results.
Thanks Memoryman for your help. I'm encouraged already! So I tried your suggestion to hold down the EOB key and press the INPUT key, and
there is no visible change. I was hoping to see a cursor...
I have a small shop with not-new CNC equipment in a small remote town in Utah. I have been at this 14 years now.
I serve a variety of customers, but most of my work is machining aluminum...
While powering up my 1991 Saeillo Mach III with FANUC OM-C, a 911 alarm appeared, so after studying all the posts I could find about the problem, I replaced the batteries and cleared memory. I have...