ok Folks - pre-waning - Hijack
I have a silly issue - it is another low IQ problem, seem to get a few of these as time goes on.
background - have an old gantry CNC that I build - it has served...
Type: Posts; User: deancnc
ok Folks - pre-waning - Hijack
I have a silly issue - it is another low IQ problem, seem to get a few of these as time goes on.
background - have an old gantry CNC that I build - it has served...
Ok, folks - As expected, this issue is a failed IQ test - plus a typo in the manual - in the manual, PN0096 should be 0 for CP/Dir - but the value needs to be a 1 for this setting - go figure 300...
funny enough - Pn006 doesn't seem to be active - poking a 3 in there "should" stop the drive without the CWL and CCWL active - but the drive still operates ...so it is a lower level than that...
sorry Dazp1976 - it takes you to a search for the manual - this link downloads it - which is the top item in that link
...
Hy Guys - This is a failed IQ test type question ... and yes this is an old thread - but it looks like you have gotten past my issue
I banged into a silly issue, I can only drive the servo...
Thanks Larry...
This is a strange one - but this worked - I cut down the length of the cable from about a meter to about a foot - and we have contact - maybe the cable was just picking up too...
I tried the tune tool - which looked like a simple way around- but this did not work.
I got the set of V95 from Kiling in 2011 so could be 9600 or 38400 depending on how old their stock was I guess....
Hi Guys
I seem to have the same issue with set of Viper 95's - I have a usb serial port - it seems it doesn't matter what rate used the data on start up is gibberish - and if one changes through...
hey for anyone that falls over this page, and is weighing up Stepper v Servo...GO servo!!!
I’ve just finished play with a new set of servos, i get good holding like a stepper, and it knows if it...
Thanks folks - grabbed a handful of different motors and controllers from ketling - shipping was a bit over the top.
Based in Melbourne...
I have built a gantry mill - the table size is 1.5m...
I grabbed some cheep a cheerful steppers and controller from Oceancontrols, but under load the max speed is just on 400mm/s. With the next step up in motor is not a nema23 frame, the next step is to...