This thread over a month old, however I will try to answer. I don't think you can “disable” it per say, but you can lock both the axes in place where they don't ever move. An M10 locks C axis and M11...
Type: Posts; User: Drew24
This thread over a month old, however I will try to answer. I don't think you can “disable” it per say, but you can lock both the axes in place where they don't ever move. An M10 locks C axis and M11...
That would be handy but as far as I know you can't. I am unfamiliar with writing script, but you might be able to write script into existing post processor to do it. Don't know though.
Sent...
It's been a while since I have used BOBCAD CAM but i believe in the tool path parameters there should be a check box to reverse it. Or once you chain you tool path geometry together you can reverse...
Have ran two of them. Not those particular models though. Their not bad. I would say average. Believe ways are on ball bearings now. (Of course all machines these days may be.) which of course means...
I know this thread is several months old, but maybe an answer will help future users. I believe in the magazine there is a mechanical switch that is pushed up at each tool then comes back down. It...
All in all Al, I believe majority of the guys feelings are we don't mind having new versions being released frequently. I know that I, and sounds like the majority of everybody else would just like...
I have V24 and we bought V25, because we were told it had a major upgrade for mill and lathe. Mill was pretty good, but basically lied to about the lathe side. Absolutely no change whatsoever. I was...
We have 2 Doosan Machines both lathes and 5 Daewoo machines. By far the old Daewoo's are much more durable and accurate than the new Doosan's. They just aren't very rigid. Probably wouldnt buy them...
Do notice that is out of round once you remove it, then put it back in? If so how much chuck press. are you using? What is the wall thickness?
If it is not chuck press. it could be stress in the...
At a quick glance. 1st Tool Offset: Look at your pp, there should be a option for how tool is called up. IE: "T1, T01, T0101" check and see what it is set at. 2nd Bobcad changing tools: in your pp...
Yes it is. Should be a question on your pp that asks: "Output data r=radius, d=diameter?" Or something along those lines. Also be sure that on the CAD side in preferences it set to lathe axis, and...
Never worked witb Mach 3 but for your second question. In order for me to get the tool facing to turn as well without going to the tool home, in your feature setup box go to the rapid tab and click...
Yeah, I love Bob, but it does have some funny quirks about it. Learning curve I am still going through. Like you said Tony 4" ineffective length is a bit much. Haha. I also wish they had a separate...
I am a little rusty with the 2 line canned cycle. I dont ever use them, but just at a glance are you really feeding that thing, at F.25 per rev? If you are asking if it is the code that fanuc uses,...
I think it might be a parameter problem. I run a daewoo lathe Fanic 18 T control i had to change i believe regular drilling to high speed drilling i think. But once i changed that parameter my canned...