261780
Saaweeeet!
The small 8mm bolt was holding the collet into the bore and the large nut was able to pull it out.
Type: Posts; User: Schwabie
261780
Saaweeeet!
The small 8mm bolt was holding the collet into the bore and the large nut was able to pull it out.
Hello,
We have a Continental 100M horizontal bandsaw that we need to get the drive wheel off of.
There was a SHCS in the center of the collet looking hub. The diameter of the large thread is bigger...
It has the video card built in.
Baking the board did not help.
Also tried a new PSU.
The monitor still shows "No signal" for a while before going blank.
The floppy drive does light up for a few...
It has the video card built in.
Baking the board did not help.
The monitor still shows "No signal" for a while before going blank.
The floppy drive does light up for a few seconds though.
Is...
A different monitor did not respond.
The power from the PSU is there, and at the correct voltages.
Maybe I'll try baking the mother board to rejoin any bad solder joints.
Do you know where to buy...
Hello, I have a Bridgeport EZ Trak DX. When I power it up I get an error - "No signal". Any ideas on where to start trouble shooting? Thank You Very Much, Gary
Hello,
We have a Sargon 652 readout mounted on a manual lathe. The cables that used to be coming out of the readout's connectors got pulled out and are now wrapped neatly around the chuck.
Does...
We're trying to mill some odd shaped profiles. The manual talks about receiving .PGM and .TXT files. Can a .DXF file be translated into a .PGM file, imported at the EZ Trak, and then generate the...
Can you tell me how to import and run a dxf or dwg file on our EZ Trak DX?
Thank You
George,
Got it! I was trying to save changes without returning to the top 1st. I ran the Y lead at 0.0 and it's now very close. Should be easy to dial it in now that I know how. Thousand thousand...
Thanks,
I got there fine, but how do I save the changes? After making changes I press " + " and the following comes up:
WAIT -- SAVING PARAMS
Drive not ready reading A:
ERROR -- SYS.BEZ not...
Hi,
I have an EZ Trak DX that's having trouble with the Y axis. The screen reads different from actual table movement (about .010" in 3"). The error shows up when moving to a position manually or...