Hi Jon
Thanks for the info. I never get too far with mine and usually end up doing something else instead. I somehow managed to get the contact closure inputs to work to start/stop the spindle so...
Type: Posts; User: mutski
Hi Jon
Thanks for the info. I never get too far with mine and usually end up doing something else instead. I somehow managed to get the contact closure inputs to work to start/stop the spindle so...
I was just going to build an adaptor as there's not really much in them, but I just checked and found them on ebay for under US$5 delivered. That's mad so I bought 2. It will just take a week or 2...
Have you worked out how to control the spindle speed from Mach3 successfully?
I've just decided I need to control speed myself, and maybe it's worth investing in a RS-485 adaptor to achieve this....
I eventually worked out that the function codes are using the serial number on the right hand side of the table. I was able to get it into terminal mode. I still have some different firmware I guess...
I tried a dedicated earth wire but it didn't help. I solved it changing to a secondary parallel card I had. Now it works just fine.
Make sure you check if there is any drift in the Z axis though....
I guess nobody here has a Fuling DZB200M. Oh well I'll just keep doing it all manual for now. I've tried emailing Fuling but their emails just bounce back again.
Cheers anyway
Matt
Hi all
I've got a Fuling DZB200M single -> 3 phase inverter. The unit came set to keyboard mode, meaning that I can control run/fwd, run/reverse, speed and stop all from the keyboard on the...
Thanks for the help everyone. Now that I know what to look for it makes it easier going through catalogues.
I'm going to order some of these:
Solid Carbide End Mills 2 Flute
Is that what I'm...
I just tried a 8mm diameter hole in 2.5mm thick aluminium with HEAPS of cutting fluid. Didn't seem to make any difference to the amount of aly that's now stuck in the flutes. The Dremel 9904 has...
I have been spraying a lubricant which is similar to WD-40 that claims to be good for cutting. This morning I got a dedicated cutting liquid from Sutton. Maybe I'm not using enough. I'll try using a...
Hi all
I'm sorry, I'm sure you answer this question a lot but the search tool just finds soooo much not really relating to my question.
I'm new to CNC routing. I've just got a small 600x400...
Thanks Al
I wired it up and the spindle works just fine. But as soon as I wound up the speed the router started moving. I suspect that I need to run a dedicated earth wire to the router. It...
Hi Al
Thanks for the reply. Does it then matter which wire goes where for a 3 phase motor? This is the spindle that was supplied (not that it has a lot of info):
GDZ65-800w spindle motor -...
Hello all
I just received my first desktop CNC router yesterday and am excited putting it all together now. The unit purchased (a YOOCNC 6040) came supplied with a Fuling DZB200M inverter....